Post by K'DaSH on May 22, 2005 23:56:57 GMT -5
Cleaned my 4 Slot inside/out, pin interfaces, all contacts with the electric cleaner I bought from RShack.
I even cleaned all my MVS carts. I made sure everything can be throughly cleaned as possible.
So I went to start it up but now it just doesn't play carts.
It used to have a garbled image, than transfer into NeoGeo screen. However now it just stays in the garbled screen and doesn't play anything. Does somebody have an idea what can be wrong?
I'm assuming it can be that I did apply some of the electronic cleaner on the boards(bottom and top) and that might of caused this. I believe this was an all purpose cleaner, so if I can clean contacts, I can clean just about anything on the board as well. A stupid mistake?
Somebody please help me out. I don't know to look anymore.
THanks anybody for your posts and tips.
I even cleaned all my MVS carts. I made sure everything can be throughly cleaned as possible.
So I went to start it up but now it just doesn't play carts.
It used to have a garbled image, than transfer into NeoGeo screen. However now it just stays in the garbled screen and doesn't play anything. Does somebody have an idea what can be wrong?
I'm assuming it can be that I did apply some of the electronic cleaner on the boards(bottom and top) and that might of caused this. I believe this was an all purpose cleaner, so if I can clean contacts, I can clean just about anything on the board as well. A stupid mistake?
Somebody please help me out. I don't know to look anymore.
THanks anybody for your posts and tips.
