Post by Candycab on Oct 25, 2003 2:49:30 GMT -5
Yup clean the cart as well as all of youre carts and the sockets in youre motherboard , remember that one dirty cart wiil scumm up all of them if its swaped in and out alot.
Another thing to look at is youre voltage ,check it where it comes out of the harness at the board since that will give you the actuall current entering the board. 5.0 to 5.05 should be fine , although some boards like more juice than others { my MV1-F wont run for shit under 5.2 volts } also see if it does it in both slots or just one of them ? ,this will help you to see if they are both getting good current ,if they arent then I would tear the board down to nothing and clean all the connections real good, as in where the two PCB oards fit together , slots etc.
Another thing to look at is youre voltage ,check it where it comes out of the harness at the board since that will give you the actuall current entering the board. 5.0 to 5.05 should be fine , although some boards like more juice than others { my MV1-F wont run for shit under 5.2 volts } also see if it does it in both slots or just one of them ? ,this will help you to see if they are both getting good current ,if they arent then I would tear the board down to nothing and clean all the connections real good, as in where the two PCB oards fit together , slots etc.
